Desktop System Controller Hub with Advanced, 8051μC-Based Auto Fan Control

Features

  • ACPI 2.0 Compliant
  • High Performance 8051
    • 2.5X average instruction execution speed improvement over the entire instruction set; i.e., typical 4-clock instruction cycle in high-performance 8051 vs. 12-clock instruction cycle in standard 8051.
    • Faster clock speed: 32 MHz vs.16 MHz in standard 8051.
    • Dual Data Pointers
    • More Interrupts: Power-Fail, External Interrupt 2, External Interrupt 3, etc.
    • A set of External Memory/Mapped Control Registers provides the 80C51 core with the ability to directly control many functional blocks of the SCH5617C.
    • 384 Bytes of RAM as part of the 8051 core
    • 4k Bytes Data RAM (869 bytes may be used to patch ROM code)
    • Twelve Interrupt Sources
    • Watch Dog Timer (WDT)
  • PECI Interface
    • Supports PECI REQUEST# and PECI AVAILABLE signalling
  • Temperature Monitor
    • Monitoring of up to Two Remote Thermal Diodes
    • Supports temperature readings from -63 degrees to +192 degrees
      • Supports monitoring of discrete diodes (3904 type diodes)
      • Supports monitoring substrate diodes (45nm & 65nm processor diodes)
    • 1/8th degree temperature resolution
    • Internal Ambient Temperature Measurement
    • Limit Comparison of all Monitored Values
  • PROCHOT_IN# Pin
    • Mapped into Temperature monitoring interrupt generation logic
    • May be used to adjust fan control limits
    • May be configured to force fans on full
  • PROCHOT_OUT Pin
  • Auto-Fan Control with ProcHot Features
    • PWM (Pulse width Modulation) Outputs (3)
      • Legacy PWM control dc fan outputs
    • High Frequency PWM Options (15kHz up to 30kHz)
    • 2 second delayed start-up for PWM outputs
    • Fan Tachometer or Lock Rotor Inputs (3)
    • Programmable linear automatic fan control based on temperature
    • Acoustic enhancement mode
    • ProcHot pins modulate Tmin
    • Fan PWM duty cycle is a function in linear mode of multiple temperatures and ProcHot signals
    • PWM Ramp Rate Closed Loop Control
  • Internal Ring Oscillator for VTR Powered Logic
  • Low Battery Warning
  • LED Control
  • SMBus Isolation Logic
  • Programmable Wake-up Event Interface
  • PC2001 Compliant
  • General Purpose Input/Output Pins (30 Host controlled, 16 8051 controlled)
  • 21 Dedicated Scratchpad registers
  • ISA Plug-and-Play Compatible Register Set
  • System Management Interrupt
  • GLUE Logic
    • IDE Reset/Buffered PCI Reset Outputs
    • Power OK Signal Generation
    • Power Sequencing
    • Power Supply Turn On Circuitry
    • Resume Reset Signal Generation
    • Hard Drive Front Panel LED
  • 2.88MB Super I/O Floppy Disk Controller
    • Licensed CMOS 765B Floppy Disk Controller
    • Software and Register Compatible with SMSC's Proprietary 82077AA Compatible Core
    • Supports Two Floppy Drives
    • Configurable Open Drain/Push-Pull Output Drivers
    • Supports Vertical Recording Format
    • 16-Byte Data FIFO
    • 100% IBM Compatibility
    • Detects All Overrun and Underrun Conditions
    • Sophisticated Power Control Circuitry (PCC) Including Multiple Powerdown Modes for Reduced Power Consumption
    • DMA Enable Logic
    • Data Rate and Drive Control Registers
    • 480 Address, Up to Eight IRQs and Four DMA Options
    • Enhanced Digital Data Separator
      • 2 Mbps, 1 Mbps, 500 Kbps, 300 Kbps, 250 Kbps Data Rates
      • Programmable Precompensation Modes
  • Keyboard Controller
    • 8042 Software Compatible
    • 8 Bit Microcomputer
    • 2k Bytes of Program ROM
    • 256 Bytes of Data RAM
    • Four Open Drain Outputs Dedicated for Keyboard/Mouse Interface
    • Asynchronous Access to Two Data Registers and One Status Register
    • Supports Interrupt and Polling Access
    • 8 Bit Counter Timer
    • Port 92 Support
    • Fast Gate A20 and KRESET Outputs
  • Serial Ports
    • Two Full Function Serial Ports
    • High Speed NS16C550A Compatible UARTs with Send/Receive 16-Byte FIFOs
    • Programmable Baud Rate Generator
      • Supports all standard baud rates up to 115k bps
      • Supports non-standard baud rates of 230k and 460k bps
    • Modem Control Circuitry
    • 480 Address and 15 IRQ Options
  • Infrared Port
    • Multi protocol Infrared Interface
    • IrDA 1.0 Compliant
    • SHARP ASK IR
    • 480 Address, Up to 15 IRQ
  • Multi-Mode™ Parallel Port with ChiProtect™
    • Standard Mode IBM PC/XT®, PC/AT®, and PS/2™ Compatible Bidirectional Parallel Port
    • Enhanced Parallel Port (EPP) Compatible - EPP 1.7 and EPP 1.9 (IEEE 1284 Compliant)
    • IEEE 1284 Compliant Enhanced Capabilities Port (ECP)
    • ChiProtect Circuitry for Protection
    • 960 Address, Up to 15 IRQ and Four DMA Options
  • LPC Interface
    • Multiplexed Command, Address and Data Bus
    • Serial IRQ Interface Compatible with Serialized IRQ Support for PCI Systems
    • PME Interface
  • Power Good Output
  • 3.3 Volt I/O
  • 128 Pin QFP Lead-Free RoHS Compliant Package

Although the information in this document has been checked and is believed to be accurate, no responsibility is assumed for inaccuracies. SMSC reserves the right to make changes to product descriptions and specifications at any time without notice. Contact your local SMSC sales office to obtain the latest specifications before placing your product order. The provision of this information does not convey any licenses under any patent rights or other intellectual property rights of SMSC or others. All sales are expressly conditional on your agreement to the terms and conditions of the most recently dated version of SMSC's standard Terms of Sale Agreement dated before the date of your order. Products may contain design defects or errors known as anomalies which may cause a product's functions to deviate from published specifications. Anomaly sheets are available upon request. SMSC products are not designed, intended, authorized or warranted for use in any life support or other application where product failure could cause or contribute to personal injury or severe property damage. Any and all such uses without prior written approval of an Officer of SMSC and further testing and/or modification will be fully at the risk of the customer. Copies of this document or other SMSC literature, as well as the Terms of Sale Agreement, may be obtained by visiting SMSC's website at http://www.smsc.com. SMSC and the SMSC logo are registered trademarks of Standard Microsystems Corporation ("SMSC"). Other names mentioned may be trademarks of their respective holders. All claims made herein speak as of the date of this material. The company does not undertake to update such statements.